Bobcat S570 U1090-51 Error Code
U1090-51 Error Code
Hub Controller Not Programmed is the main cause of U1090-51 error.The condenser converts gases into liquids, which expels heat from your rig. Materials can build up over time, causing a layer of dirt and grime to form on the condenser's coils. Your AC system will only blow hot air since the refrigerant fails to cool down.
Tip For S570 Model
There is a control lock sensor in the left
console which deactivates the hydraulic
control levers (joysticks) and the traction
drive system when the control console is
raised. The console must be in the locked
down position for the hydraulic control levers
(joysticks) and traction system to operate.
NOTE: If the control lock sensor does not deactivate
the control levers and traction system when
console is raised, see your Bobcat S570 dealer for
service.